[Federal Register: May 6, 2004 (Volume 69, Number 88)]
[Notices]
[Page 25445-25446]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr06my04-89]
[[Page 25445]]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF LABOR
Occupational Safety and Health Administration
[Docket No. C-08]
Nationwide Site-Specific Targeting (SST) Inspection Program
AGENCY: Occupational Safety and Health Administration, USDOL.
ACTION: Request for comments.
-----------------------------------------------------------------------
SUMMARY: The Occupational Safety and Health Administration (OSHA) is
soliciting comments on its nationwide Site-Specific Targeting (SST)
inspection program, which was first implemented in April 1999 and
updated annually, in order to determine more accurately how this
program is accomplishing its goal of effectively using OSHA's
enforcement resources.
DATES: Written comments must be submitted on or before July 6, 2004.
ADDRESSES: Send two copies of your comments to Docket Office, Docket
No. C-08, Room N-2625, Occupational Safety and Health Administration,
U.S. Department of Labor, 200 Constitution Avenue, NW., Washington, DC
20210, Telephone: 202-693-2350. Comments of 10 pages or fewer may be
faxed to the Docket Office at the following FAX number: 202-693-1648,
provided that the original and one copy are sent to the Docket Office
immediately thereafter.
You may also submit comments electronically to http://ecomments.osha.gov.
Information such as studies and journal articles
cannot be attached to electronic submissions and must be submitted in
duplicate to the docket office address listed above. Such attachments
must clearly identify the respondent's electronic submission by name,
date, and subject, so that they can be attached to the correct
submission.
FOR FURTHER INFORMATION CONTACT: Richard E. Fairfax, Occupational
Safety and Health Administration, Directorate of Enforcement Programs,
Room N-3119, U.S. Department of Labor, 200 Constitution Avenue, NW.,
Washington, DC 20210, Telephone 202-693-2100. For electronic copies,
contact OSHA's Web page on the Internet at http://www.osha.gov.
SUPPLEMENTARY INFORMATION: The purpose of the Occupational Safety and
Health Act is to assure, so far as possible, safe and healthful working
conditions for every working man and woman in the nation. In order to
achieve that goal, the Act requires employers to furnish their
employees with employment which is free from recognized hazards that
are likely to cause death or serious physical harm, and to comply with
occupational safety and health standards issued by the Secretary of
Labor. In order to determine whether employers are providing safe and
healthful workplaces, OSHA conducts unannounced workplace inspections
as part of the Agency's overall enforcement strategy.
Of the approximately 35,000 inspections OSHA conducts in a year,
about 3,000 are Site-Specific Targeting (SST) inspections. The
remaining inspections are imminent danger, fatality, catastrophe,
complaint, referral, follow-up, and other programmed inspections. The
other programmed inspections are mainly Emphasis Program inspections,
which focus on a particular safety or health hazard (e.g., amputation,
silica), or the hazards of a specific industry (e.g., logging, nursing
homes).
Since 1996, OSHA has been using the annual OSHA Data Initiative
survey to collect data from employers in an effort to better identify
worksites for inspection. The Data Initiative gives OSHA a targeting
tool it did not previously have: the ability to determine each surveyed
worksite's Lost Work Day Injury and Illness (LWDII) rate.\1\ Prior to
the Data Initiative, OSHA targeted its compliance efforts on an
industry-by-industry basis, relying on general industry-based data
received from the Bureau of Labor Statistics (BLS) to determine where
to focus its enforcement program and outreach efforts. Although
industry data are extremely useful for identifying categories of
problems (e.g., specific industries and occupations at risk, etc.),
aggregation of data by industry masks the experience of individual
employers. OSHA would not know until it arrived at an employer's
facility whether the employer had a high injury-illness rate or not,
only that the employer was in a high-rate industry. It was thought that
using site-specific data would be a better approach. Therefore, in
early 1996, the Data Initiative was established to give OSHA the
capability to focus on those establishments with serious safety and
health problems. The Data Initiative survey was initially sent to
establishments that had 60 or more employees, but since 1999 the data
surveys have been sent to establishments with 40 or more employees.
Each year, OSHA sends its data survey form (the ``OSHA Work-Related
Injury and Illness Data Collection Form'') to approximately 80,000 non-
construction establishments, requesting from each employer (1) the
average number of employees who worked for the employer during the
prior calendar year, (2) the total hours the employees worked during
the prior year, and (3) the summary injury and illness data from the
employer's OSHA Log form.
---------------------------------------------------------------------------
\1\ Lost Workday Injury and Illness (LWDII) rate: This includes
cases involving days away from work and restricted work activity and
is calculated based on (N / EH) x (200,000) where N is the number of
lost work day injuries and illnesses combined; EH is the total
number of hours worked by all workers during the calendar year; and
200,000 is the base for 100 full-time equivalent workers. For
example: Workers of an establishment including management,
temporary, and leased workers worked 645,089 hours at this worksite.
There were 22 lost workday injuries and illnesses from the OSHA 200
(totals in columns 2 and 9). The LWDII rate would be (22 / 645,089)
x (200,000) = 6.8.
---------------------------------------------------------------------------
With the Data Initiative in place, in April 1999 OSHA implemented
its first nationwide site-specific targeting plan (known as the SST)
for comprehensive programmed inspections in non-construction worksites.
This program applies only to Federal jurisdiction states and has also
been updated annually.\2\ For the most current SST go to OSHA's Web
site at http://www.osha.gov and click on D in the alphabet at the top
of the page, then Directives, then Information Date, and finally 2004,
and scroll down to April and the current SST.
---------------------------------------------------------------------------
\2\ The 1997 injury and illness data that was collected by the
1998 Data Initiative (survey) was used in the 1999 Site-Specific
Targeting plan. Likewise, the 2002 data, collected by the 2003 Data
Initiative, is currently being used for the 2004 Site-Specific
Targeting plan.
---------------------------------------------------------------------------
The SST inspection plans are based on the self-reported injury and
illness information submitted by employers in OSHA's Data Initiative.
An LWDII rate is selected that will provide the number of
establishments for SST inspections that OSHA anticipates it will be
able to conduct during the year. From the data submitted, OSHA compiles
two inspection targeting lists, a primary and a secondary list of non-
construction worksites. The primary list for 1999 included the
establishments that reported an LWDII at or above 16.0, which provided
approximately 2,200 establishments for inspection. In 2000, and until
2004, the LWDII cut off was at or above 14.0, which provided 3,000 to
4,200 establishments. Each Federal OSHA Area Office receives a list of
establishments for their primary targeting list, and is expected to
complete inspections of these establishments in about a year. After an
area office completes its primary list, the secondary list is used. The
secondary list for 1999 included establishments that reported an LWDII
of 10.0 or greater (but less than 16.0). In 2000, and until 2004, the
secondary list
[[Page 25446]]
included establishments reporting an LWDII of 8.0 or greater (but less
than 14.0). To put these numbers in perspective, the national average
LWDII rate for 2001 was 2.8--that is, a worksite with almost three
injuries or illnesses resulting in lost work days for every 100 full-
time workers.
Establishments selected for a site-specific inspection receive both
a comprehensive safety and a comprehensive health inspection.
Occasionally, if an employer has been greatly improving its safety and
health performance, an SST inspection may be a ``records only''
inspection. That is, if the employer's LWDII rate, as calculated by the
OSHA compliance officer during the inspection, shows the establishment
to have a low LWDII rate for the last two consecutive years, then the
compliance officer may confine the inspection to a review of the
employer's safety and health records.
Beginning with the SST-03 plan, and continuing with the SST-04
plan, an additional factor was introduced to improve the selection of
establishments for inspection. This factor is the establishment's Days
Away from Work Injuries and Illness (DAFWII) case rate. The DAFWII is a
component, or subset, of the LWDII. The DAFWII is comprised of injury
and illness cases that involve at least one day away from work. The
LWDII is comprised of cases that involve at least one day away from
work or a day of restricted work activity. Under the assumption that an
injury or illness which requires a day away from work is more serious
than one which requires restricted work activity, using the DAFWII as a
targeting criterion will further identify establishments with the
greatest number of serious hazards. Therefore, under the SST-03 plan,
if an establishment's LWDII rate is 14.0 or more, or its DAFWII case
rate is 9.0 or more, it will be on the primary inspection list.
Likewise, if an establishment's LWDII rate is 8.0 or greater (but less
than 14.0), or its DAFWII case rate is 4.0 or greater (but less than
9.0), it will be on the secondary inspection list.
Due to changes in OSHA's recordkeeping regulations, which became
effective January 1, 2002, the LWDII rate is being replaced by the Days
Away from work, Restricted, or job Transfer (DART) rate starting with
the workplace injury and illness data collected in 2002. The
computation of the DART rate is almost identical to that of the
LWDII.\3\
---------------------------------------------------------------------------
\3\ Days Away from work, Restricted, or job Transferred (DART)
rate: This includes cases involving days away from work, restricted
work activity, and transfers to another job. It is calculated based
on (N / EH) x (200,000) where N is the number of cases involving
days away, and/or restricted work activity, and/or job transfer; EH
is the total number of hours worked by all employees during the
calendar year; and 200,000 is the base number of hours worked for
100 full-time equivalent employees. For example: Employees of an
establishment including management, temporary, and leased workers
worked 645,089 hours at this worksite. There were 22 injury and
illness cases involving days away and/or restricted work activity
and/or job transfer from the OSHA 300 Log (total of column H plus
column I). The DART rate would be (22 / 645,089) x (200,000) = 6.8.
---------------------------------------------------------------------------
The intention of the SST and the Data Initiative is to help OSHA
make more effective use of its enforcement resources. In order to
achieve OSHA's goal of reducing the number of injuries and illness that
occur at individual worksites/establishments, the SST directs
enforcement resources to those worksites where the highest rate of
injuries and illnesses have occurred. OSHA seeks input from the public
in order to determine more accurately how its annual nationwide
targeting program is accomplishing its goal of effectively directing
OSHA's enforcement resources. Any suggestions that would assist the
Agency in improving the SST are welcome, as well as any information as
to how the SST program is perceived by the employer and worker
communities. Specifically: Are the LWDII/DART rate and the DAFWII case
rate appropriate measurement tools for the SST? Should OSHA consider
other measures for injury and illnesses at individual establishments?
If yes, what measures should be considered? Should OSHA be looking at
injury and illness data over multiple years rather than in a single
year? Should an establishment's priority for inspection take into
account whether the establishment is in an industry with a high rate or
a low rate of citations? Should the SST include additional focuses such
as on specific industries, or past citation history? Are there
particular areas/hazards OSHA should be focusing its enforcement
efforts on?
Authority: This document is issued under Sec. 8(a) and 8(b),
Pub. L. 91-596, 84 Stat. 1599 (29 U.S.C. 657).
Signed in Washington, DC, this 27th day of April, 2004.
John L. Henshaw,
Assistant Secretary of Labor.
[FR Doc. 04-10316 Filed 5-5-04; 8:45 am]
BILLING CODE 4510-26-P